These are the steps to configure the Ubiquiti Bullet. Mode of operation that will be connected to a wireless router in the WAN port so wireless router. Like all Ubiquiti equipment the Bullet is capable of being set in any wireless mode – access point, station, bridge, router, AirMax (for P2P/P2MP) AP/station. Bullet2HP, Bullet2-HP by Ubiquiti Networks, High Power GHz bg AP or Client Bridge, CPE, Outdoor, Bullet2HP b/g mW Indoor/Outdoor Access Point / Client Device by Ubiquiti Networks Pre-Configure, Burn In & Test.
|Published (Last):||8 September 2013|
|PDF File Size:||8.7 Mb|
|ePub File Size:||2.56 Mb|
|Price:||Free* [*Free Regsitration Required]|
In the case of the Platypus boat, the Bullet is used as an access point hotspotgenerating a long-range WiFi WLAN network for communcation between the boat and the on-shore devices. As the radio is powered through PoE, it comes with a PoE adapter as seen in the conciguration below exact model may differ:.
From a factory reset, the Bullet can be accessed through bullwt2hp standard IP However, its default settings are WiFi station and bridge mode.
Ubiquiti Bullet2HP Installation and Onboard Wifi installation –
For this initial setup, it is recommended to connect the Bullet to a conventional computer, as the configuration is done via browser or to a Raspberry running a graphical interface OS. In Linux, we can configuratikn connect to the bullet through the ifconfig command.
After connecting the LAN adapter port into the computer, run:.
To manually assign an IP and connect, run:. The Bullet configuration page can the be accessed in a browser by the address http: A untrusted connection or security certificate warning may appear, which can be safely ignored.
A screen like the one below will appear:. To configure the Bullet as an access point, change the following configurations in the Wireless tab:. Bridge and Router mode.
Configuring the Ubiquity Bullet M2HP Radio — platypus_boat_doc documentation
Thus, in the case of the Platypus boat, the radio must be configured in Bridge mode. In the Network tab, modify the following fields to configure the radio in bridge mode:. Click Change and then Apply. Once again, this can be done with the ifconfig command in Linux.
For the Raspberry, the interface used is the Ethernet e. Setting IP by ifconfig will assign the IP temporarily to the port.
An IP must also be manually set for the WiFi devices. After connecting the LAN adapter port into the computer, run: Bridge Management IP Address: Read the Docs v: